Silicone sealant Abro SS-1100-WH

Universal 100% silicone sealant based on vinegar acid. It is suitable for internal and external works; it is frost-resistant. After hardening, it becomes water-resistant, preserves elasticity, is resistant to mechanical and temperature impacts (from -50 to +200°C). It is used to seal and glue all types of joints and seals. It is suitable to glue glasses. It can be used in all cases when insulation from external impacts, high moisture-resistance, and strength are required. It has excellent adhesion to aluminum, glass, porcelain, rubber, ceramics, plastic, painted surfaces, non-oily wood and metal. Benefits: frost-resistant, moisture-resistant, excellent elasticity, a wide operating temperature range from -50 to +200°C, resistant to chemical solutions. APPLICATION. 1. The surface must be clean, dry, and non-greasy. 2. Cut the tip of the cartridge and screw the applicator. 3. Cut the applicator to the necessary diameter at the angle of 45 degrees. 4. Squeeze the sealant holding the cartridge at a 45-degree angle to the surface. 5. Remove excess with a paper wipe or fabric wet with alcohol. 6. Cut the hardened sealant with a sharp knife. 7. In about 5 minutes after the application, the film is formed on the surface. It hardens fully in 24 hours. Repeated sealant usage: In case of incomplete usage, squeeze a drop of the sealant. During the repeated application, remove the dried-up plug. It is difficult to paint this product. The fully hardened product is safe.