Fuel system cleaners Abro MF390

Engine flush (443 ml). It allows you to flush the engine oil system and wash off all types of scale, sludge, etc. Before each oil change, it helps improve engine performance properties and extend its service life. It is a highly concentrated fluid with special additives; one can is enough for full engine flushing. It allows you to do without special flushing oils. Application: Make sure that the oil level complies with the optimum (if necessary, top up the oil). Pour the can into the cooled-down engine right before the oil and filter change. Start the engine and ensure its idle run within 5 minutes. Prolong the time up to 20 minutes in case of heavy dirt. It is strictly forbidden to drive with the flush added in the oil system! Stop the engine, drain the used oil and remove the old oil filter. In case of a long interval between engine flushes or oil changes and in case of worn-out engines, it is strongly recommended to remove and thoroughly clean the crankcase pan. Install the new oil filter and add the oil to the necessary level recommended by the manufacturer.