Glass cleaner Philips HRK00XM

The set contains all the necessary items for cleaning headlights: - 1 vessel with water-based fluid for preliminary cleaning (29.5 ml); 1 vessel with cleaning/polishing fluid (29.5 ml); 1 vessel with gloss restoration/protection product (29.5 ml); 1 sheet of sandpaper, 600 grade (coarse); 1 sheet of sandpaper, 1500 grade (sanding)- 1 sheet of sandpaper, 2000 grade (polishing); - 10 paper towels; - 1 pair of gloves (one size). Philips care set for headlights allows you to remove taint and yellowness because of the sun. The surface is as if new! The special coating protects from the UV rays. Instructions for application: (1) Composition. (2) Cover the area around the headlight with a masking tape (it is not included in the set, must be purchased separately). (3) Step 1: take one towel and fold it 4 times. Thoroughly shake the water-based product for preliminary preparation. Squeeze it on the towel. (4) Remove dirt from the headlight in circular motions. Do not spend all the water-based product for preliminary preparation, leave some amount for step 3. (5) Step 2: take the sandpaper of 1500 grade (if there are small and varying impurities, use the sandpaper of 600 grade, then take finer sandpaper), wet it with water and clean the headlights strictly in the vertical direction. (6) Then take the sandpaper of 2000 grade and repeat step 2. (7) Step 3: take one towel and fold it 4 times. Thoroughly shake the bottle with headlight cleaner/polish before squeezing it on the towel. (8) Apply the product on the headlight in circular motions. (9) As soon as the headlight starts shining, take the towel and fold it 4 times. Squeeze the water-based product for preliminary preparation on the towel. (10) Remove residues of the headlight cleaner/polish using the water-based product in circular motions. (11) Step 4: take a lint-free paper towel, fold it 4 times and squeeze the product for gloss restoration and protection on it. If there is too much product on the towel, wring it out. (12) Softly apply the product on the plastic surface, avoiding streaks and bubbles. It is recommended to apply it in several layers. Leave it to dry for about 5 minutes before the next layer is applied. Set